Asus TS500-E2 - Manual (Page 31)

2 - 1 1 2 - 1 1 2 - 1 1 2 - 1 1 2 - 1 1 A S U S T S 5 0 0 - E 2 A S U S T S 5 0 0 - E 2 A S U S T S 5 0 0 - E 2 A S U S T S 5 0 0 - E 2 A S U S T S 5 0 0 - E 2
2.4.3 2.4.3 2.4.3 2.4.3 2.4.3 Installing a DIMM Installing a DIMM Installing a DIMM Installing a DIMM Installing a DIMM
Make sure to unplug the power supply before adding or removing DIMMs or
other system components. Failure to do so may cause severe damage to
both the motherboard and the components.
To install a DIMM:
1. Unlock a DIMM socket by
pressing the retaining clips
outward.
2. Align a DIMM on the socket
such that the notch on the
DIMM matches the break on
the socket.
3. Firmly insert the DIMM into the
socket until the retaining clips
snap back in place and the
DIMM is properly seated.
2.4.4 2.4.4 2.4.4 2.4.4 2.4.4 Removing a DIMM Removing a DIMM Removing a DIMM Removing a DIMM Removing a DIMM
Follow these steps to remove a DIMM.
1. Simultaneously press the retaining
clips outward to unlock the DIMM.
2. Remove the DIMM from the socket.
• A DDR2 DIMM is keyed with a notch so that it fits in only one direction.
Do not force a DIMM into a socket to avoid damaging the DIMM.
• The DDR2 DIMM sockets do not support DDR DIMMs. DO NOT install
DDR DIMMs to the DDR2 DIMM sockets.
Support the DIMM lightly with
your fingers when pressing the
retaining clips. The DIMM might
get damaged when it flips out
with extra force.
D D R 2 D I M M n o t c h D D R 2 D I M M n o t c h D D R 2 D I M M n o t c h D D R 2 D I M M n o t c h D D R 2 D I M M n o t c h 1
2
1
U n l o c k e d r e t a i n i n g c l i p U n l o c k e d r e t a i n i n g c l i p U n l o c k e d r e t a i n i n g c l i p U n l o c k e d r e t a i n i n g c l i p U n l o c k e d r e t a i n i n g c l i p
D D R 2 D I M M n o t c h D D R 2 D I M M n o t c h D D R 2 D I M M n o t c h D D R 2 D I M M n o t c h D D R 2 D I M M n o t c h
1
2
3