Asus TS500-E2 - Manual (Page 38)

C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p 2 - 1 8 2 - 1 8 2 - 1 8 2 - 1 8 2 - 1 8
2.7 Hard disk drives
2.7.1 2.7.1 2.7.1 2.7.1 2.7.1 Installing a hot-swap SCSI HDD Installing a hot-swap SCSI HDD Installing a hot-swap SCSI HDD Installing a hot-swap SCSI HDD Installing a hot-swap SCSI HDD
If you purchased an RS8 or RS4 configured model, follow these instructions
to install a hot-swap SCSI hard disk drive (HDD).
1. Open the front bezel to access the hot-swap drive trays.
2. Release a drive tray by pushing
the spring lock to the right, then
pulling the tray lever outward. The
drive tray ejects slightly after you
pull out the lever.
3. Firmly hold the tray lever and pull
the drive tray out of the bay.
4. An empty drive tray requires a metal bracket for support. Use a Phillips
(cross) screwdriver to remove the bracket when you are ready to install
a hard disk in the drive tray.
M e t a l b r a c k e t M e t a l b r a c k e t M e t a l b r a c k e t M e t a l b r a c k e t M e t a l b r a c k e t
T r a y l e v e r T r a y l e v e r T r a y l e v e r T r a y l e v e r T r a y l e v e r S p r i n g l o c k S p r i n g l o c k S p r i n g l o c k S p r i n g l o c k S p r i n g l o c k