Asus RS260-E3/RS8 - Manual (Page 24)

C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p 2 - 4 2 - 4 2 - 4 2 - 4 2 - 4
Rear half Rear half Rear half Rear half Rear half
3. Firmly hold the rear half of the top
cover, then remove it from the
chassis.
To remove the rear half of the top cover:
1. Loosen the thumbscrew that
secures the top cover on the rear
part of the chassis.
You need to remove the front half of the top cover before you can remove
the rear half of the top cover. Refer to section “2.1.1 Removing the top
cover (front half)” for instructions.
The barebone server without the
top cover is shown on the right.
T h u m b s c r e w T h u m b s c r e w T h u m b s c r e w T h u m b s c r e w T h u m b s c r e w
2. Remove the screw on the rear half
of the cover.