Asus RS260-E3/RS8 - Manual (Page 62)

C h a p t e r 3 : I n s t a l l a t i o n o p t i o n s C h a p t e r 3 : I n s t a l l a t i o n o p t i o n s C h a p t e r 3 : I n s t a l l a t i o n o p t i o n s C h a p t e r 3 : I n s t a l l a t i o n o p t i o n s C h a p t e r 3 : I n s t a l l a t i o n o p t i o n s 3 - 4 3 - 4 3 - 4 3 - 4 3 - 4
3.3 Attaching the rack rails
To attach the rack rails:
1. Select two units of space (2U) on the rack where you want to install the
barebone server.
2. Install the nuts on the holes of the 2U space on the rack front.
3. Install the nuts on the holes of the 2U space on the corresponding rack
rear.
4. Measure the depth of the rack to
determine the length of the rack
rails.
5. Take two pieces of rack rail,
consisting of the middle piece with
the pre-installed rear end, and one
front end (left or right).
Attach the front end to the middle
piece using the supplied nuts and
screws. Make sure that the front
end dent supports the middle
piece.
7. Measure the rack rail when
assembled to make sure that it fits
the rack.
R i g h t f r o n t R i g h t f r o n t R i g h t f r o n t R i g h t f r o n t R i g h t f r o n t
o f t h e r a c k
o f t h e r a c k o f t h e r a c k o f t h e r a c k o f t h e r a c k
L e f t f r o n t L e f t f r o n t L e f t f r o n t L e f t f r o n t L e f t f r o n t
o f t h e r a c k
o f t h e r a c k o f t h e r a c k o f t h e r a c k o f t h e r a c k
D e n t D e n t D e n t D e n t D e n t
M i d d l e p i e c e M i d d l e p i e c e M i d d l e p i e c e M i d d l e p i e c e M i d d l e p i e c e