Asus AP1710-E1 - Manual (Page 27)

2 - 3 2 - 3 2 - 3 2 - 3 2 - 3 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1
2.1.2 2.1.2 2.1.2 2.1.2 2.1.2 Reinstalling the side cover Reinstalling the side cover Reinstalling the side cover Reinstalling the side cover Reinstalling the side cover
To reinstall the side cover:
1. Match and insert the hooks of
the cover to the elongated
holes on the side of the chassis.
All the six hooks (three each on
the top and bottom) of the
cover must properly fit the
designated holes.
2. Slide the cover toward the front
until it snaps in place.
3. Push down the chassis lock to
secure the side cover.
You may need to remove some of the installed components to access
the DIMM sockets and internal connectors. Refer to section “2.10
Removable components” for instructions.
Viewing the internal structure Viewing the internal structure Viewing the internal structure Viewing the internal structure Viewing the internal structure
Without the side cover, the internal structure and installed components of
the barebone server vary depending on the model you purchased. Refer to
section “1.5 Internal features” for the different model configurations.
Perform the procedures in the succeeding sections to install the CPU,
system memory, disk drives, and expansion cards; replace fans and power
supply; and connect the system cables.
1 1 1 1 1
2 2 2 2 2
3 3 3 3 3