Asus AP1710-E1 - Manual (Page 45)

2 - 2 1 2 - 2 1 2 - 2 1 2 - 2 1 2 - 2 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1
7. Connect the IDE and power
cables to their corresponding
connectors on the back of the
drive.
8. Follow steps 2 to 6 to install
other hard disk drives.
9. Reinstall the front panel
assembly when done.
3. Attach R a i l 2 R a i l 2 R a i l 2 R a i l 2 R a i l 2 to the other side of the drive as shown. The rail end
should be on the side of the drive connectors.
6. Push the drive all the way to the
depth of the bay until the rail
locks clicks, indicating that the
drive is securely in place.
4. Check the HDD jumper setting.
Refer to the label pasted on the
HDD for the description of
jumper settings. The setting
“Cable Select” is recommended.
5. Carefully insert the drive into a
bay on the front panel.
H o l e 1 H o l e 1 H o l e 1 H o l e 1 H o l e 1 H o l e 3 H o l e 3 H o l e 3 H o l e 3 H o l e 3 R a i l h a n d l e R a i l h a n d l e R a i l h a n d l e R a i l h a n d l e R a i l h a n d l e D r i v e c o n n e c t o r s D r i v e c o n n e c t o r s D r i v e c o n n e c t o r s D r i v e c o n n e c t o r s D r i v e c o n n e c t o r s