Asus AP1710-E1 - Manual (Page 33)

2 - 9 2 - 9 2 - 9 2 - 9 2 - 9 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1
2.4 System memory
2.4.1 2.4.1 2.4.1 2.4.1 2.4.1 Overview Overview Overview Overview Overview
The motherboard comes with four Double Data Rate (DDR) Dual Inline
Memory Modules (DIMM) sockets.
A DDR module has the same physical dimensions as a DDR2 DIMM but has a
184-pin footprint. DDR DIMMs are notched to match the break on the
socket and ensure correct installation.
The figure illustrates the location of the DDR DIMM sockets:
2.4.2 2.4.2 2.4.2 2.4.2 2.4.2 Memory configurations Memory configurations Memory configurations Memory configurations Memory configurations
You may install 256 MB, 512 MB, 1 GB, 2 GB, and 4 GB registered ECC DDR
DIMMs into the DIMM sockets.
• Always install DIMMs with the same CAS latency. For optimum
compatibility, we recommend that you obtain memory modules from
the same vendor. Visit the ASUS website (www.asus.com) for the
latest QVL.
• Due to chipset resource allocation, the system may detect less than
8 GB system memory when you installed four 2 GB DDR memory
modules.
• This motherboard does not support memory modules made up of
128 Mb chips or double-sided x16 memory modules.
• Installing DDR DIMMs other than the recommended configurations
may cause memory sizing error or system boot failure. Use any of
the recommended configurations on the next page.
• When all four sockets are populated with 2 GB DIMMs (total 8 GB),
the system may detect only less than 8 GB due to resource
allocation on onboard devices.
NCLV-D
NCLV-D 184-Pin DDR DIMM sockets
80 Pins 104 Pins
DDR_A1
DDR_B1
DDR_A2
DDR_B2