Asus AP1710-E1 - Manual (Page 79)

2 - 5 5 2 - 5 5 2 - 5 5 2 - 5 5 2 - 5 5 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1 A S U S A P 1 7 1 0 - E 1
To remove the 600 W single power supply module:
1. Loosen the thumbscrew that
secures the power supply
metal plate. Do not remove
the thumb screw from the
metal plate.
T h u m b s c r e w T h u m b s c r e w T h u m b s c r e w T h u m b s c r e w T h u m b s c r e w
2. Hold the metal plate bar and
push it downward to release
the plate from the chassis.
Remove the metal plate
completely.
3. Use one hand to push the
power supply module from
inside the power supply cage,
then carefully pull out the
module from the chassis.
M e t a l p l a t e b a r M e t a l p l a t e b a r M e t a l p l a t e b a r M e t a l p l a t e b a r M e t a l p l a t e b a r
Make sure to unplug A L L A L L A L L A L L A L L power cables from the system devices before
removing the power supply module.
1. 24-pin ATX (motherboard power connector; hidden behind PSU )
2. 8-pin +12V (motherboard power connector; hidden behind PSU )
3. 2 x 4-pin plugs (SCSI/SATA backplane)
4. 4-pin plug (floppy disk drive; hidden )
5. 2 x 4-pin plugs (second SCSI backplane, if available)