Xylem 19-001-350R2 PACE Integrated Pump Controller Human Machine Interface (HMI) for the Silent Storm VFD Pumping System – Technician Guide User Manual
Page 13
13
The Lake Level Control screen shows the pump
number, whether the pump is currently on or off, if
the enclosure switch is set to on or off, and also
gives a pump’s runtime total in hours. If a well pump
is used, the well level is shown in feet in a read-only
field.
Tap [Next] to move to the next status screen.
Lake Level/Transfer/Timed Pump Monitoring
Screen:
Figure 22: Lake Level Controls Monitoring
Screen
This screen allows you to see the status of the Lake
Level/Timed pump control system at a glance.
Pump status (Off, Run, Fault), switch status
(On/Off), Level settings can be viewed/adjusted
(When logged in as Admin, Technician, or
Supervisor only), pump hours can be monitored,
Start/Duration times for timed pumps can be
monitored, lake levels and/or probe status (as
equipped).
Timed Pump Monitoring Screen (Non-Integrated
Only)
Currently, only one timed pump can be set up and
monitored on the Timed Pumps screen. The screen
is read only, and gives the pump number, status,
and the total run time in hours.
Red, no animation: Stopped
Green, rotating center: Running
Yellow, flashing center: Fault condition
Select [Next] to move to the next status screen.
Figure 23: Timed Pump Monitoring Screen
Simple Filters Monitoring Screen
Simple filters include Wye strainers and other filters
controlled by a simple on-off flush signal. This
screen will monitor all installed filters. ∆P denotes
differential pressure.
Red, no animation: Stopped
Green, rotating center: Running
Yellow, flashing center: Fault condition
A green colored graphic denotes that the filter is
flushing.
Other information displayed includes filter number,
run time (in hours), and whether the enclosure
switch is set to on or off.
Tap [Next] to move to the next status screen.
Figure 24: Simple Filters Monitoring Screen
Scanner Filters Monitoring Screen
The scanner filter monitoring screen shows the
status of a single filter with up to eight chambers.
The inset box shows if the flush cycle is on or off, if
the enclosure filter switch is set to on or off, if ΔP is
bypassed, and if a filter faults, ‘Fault’ blinks as a
notification. Text showing that ΔP is present or
absent is displayed below the box.