Xylem 19-001-350R2 PACE Integrated Pump Controller Human Machine Interface (HMI) for the Silent Storm VFD Pumping System – Technician Guide - Manual (Page 31)

31
Figure 72: Setup / Configuration File
Exit Application
Tap [Exit] from the Home Screen.
Exit will close the HMI interface and exit the
application. When [Exit] is tapped, the CEView
desktop is then displayed that gives the user the
ability to change operating system files. A warning
appears asking you to confirm your decision.
CAUTION:
No changes should be made to the operating
system unless directed by a Flowtronex
Customer Service technician. Functionality of
the HMI and the pumping station may be
affected by changes.
Figure 73: Exit App Warning
Networking and Remote Access
The general instructions and screen-shots provided
in this manual for operating the HMI may be used
when accessing the interface via the internet on a
personal computer.
For instructions related to configuring your personal
computer, please see appendix G.
Please note that when using a personal computer,
the touch-screen functionality is not available. To
navigate the screens:
• Click on the buttons with your mouse.
• Use your mouse to click in a blank
field. Enter text or numbers using a
standard PC keyboard.
Remote Software Log In
An identical version of the HMI software may be
accessed remotely by an Internet IP (Internet
Protocol) address. Type the following address into
an internet browser:
From within your network (at the maintenance
facility), open your web browser and type the
following URL into the address line:
http://192.168.1.15 . This will take you directly to the
HMI’s web server.
To access your pump station from outside of your
network, you must first determine the IP address of
the router as seen from the internet. Note that this
can be somewhat difficult to determine without help
from your IT department (if you have one). The
router IP address can be found through the use of
3
rd party IP address resolution sites (available on
the internet) or by navigating the router’s
administration pages.
In the pop up screen, enter your username and
password to log in.
After the HMI interface opens, the user type (from
Guest to Supervisor) may be changed by the
standard procedure described for touch panel
log in.
Web Reports
Internet users of the HMI interface can also view
and print different reports. There is an Alarms
Report, Historical Report, Usage Report, and
Factory Reports. The navigation bar allows the user
to access each report’s setup screen and print the
report. The trends screen can also be customized,
a feature which is unavailable in the local HMI
interface.
Log on to Web Reports
Log on to the reports menu by typing the following
in the address bar of your browser:
http://000.000.000.00/reportmenu.html
where 000.000.000.00 is replaced by your IP
address. Enter you username and password in the
log in screen displayed. Click [OK] to submit or
[Cancel] to cancel.
You can obtain your IP address through your IT
department or internet service provider.