Xylem 19-001-350R2 PACE Integrated Pump Controller Human Machine Interface (HMI) for the Silent Storm VFD Pumping System – Technician Guide - Manual (Page 17)

17
CAUTION:
Synchronization should not be done while
using the Internet-based remote client as this
has the potential to negatively affect the time
settings of the system. Syncing should only be
performed locally.
Figure 37: Set/Sync HMI-PLC Date/Time
Lamp Test
Tap [Lamp Test] from the User Setup menu.
Holding this button for 3 seconds causes all lights
on the control panel to light up briefly. Any bulb that
does not light up should be replaced.
LOCKOUT SETUP
Tap [Lockout Setup] from the Setup Menu.
Lockout setup is similar in appearance to the
Lockout View accessible in the Operation menu.
Individual lockouts may be setup by tapping over
each lockout inset. Tapping any inset opens a
configuration window. The day, start time, and
duration may be entered in the interval tab at the
top. In the parameter tab, the combo number,
setpoint, and speed can be entered. Tap [Apply] to
save settings or [Close] to discard any changes.
An individual lockout setup screen is shown below.
Figure 38: Individual Lockout Setup
Figure 39: Parameter Tab in Lockout Setup
The screen shown in Figure 38 sets up a lockout for
Friday beginning at 4:59 AM. The duration is set to
be 1 hour and 1 minute. Thus this lockout will end
at 6:00 AM on Friday. The animated display gives
an indication about time. The Parameter tab
enables a user to define Combo number, maximum
pressure, and maximum speed in RPM.
SECURITY SETUP
Tap [Security Setup] from the Setup Menu.
The Supervisor can change the password assigned
to him/her, and set the number of days after which
the password expires (in the editable field). To
change the password, tap [Change Password] to
change the supervisor password. Enter the new
password in the ‘Password’ and ‘Confirm Password’
field. Tap [Apply] to save changes.
NOTE: Tap [Generate App Code] if your current
Technician password has expired. Use this App
code when calling customer service to obtain a new
password. The [Generate App Code] button is
available to any user without a password.