Xylem 19-001-350R2 PACE Integrated Pump Controller Human Machine Interface (HMI) for the Silent Storm VFD Pumping System – Technician Guide - Manual (Page 14)

14
Red, no animation: Stopped
Green, rotating center: Running
Yellow, flashing center: Fault condition
Tap [Next] to move to the next status screen.
Figure 25: Scanner Filter Monitoring Screen
Solid Separators Monitoring Screen
This screen shows the status information for up to
five installed filters. The Solid Separators Status
icon also shows the filter number, the status,
whether the enclosure switch (Switch) is set to on
or off, if the Flushing switch is set to on or off, the
time until the next flush is shown in seconds (‘Til
Flush), and filter Runtime is displayed in hours
(Runtime).
Red, no animation: Stopped
Green, rotating center: Running
Yellow, flashing center: Fault condition
Tap [Next] to move to the next status screen.
Figure 26: Solid Filter Monitoring Screen
ALARMS
Tap [Alarms] from the Operations menu.
The alarms screen shows all current and
unacknowledged alarm events. Use the vertical
scroll bar to view all alarm events if necessary.
The latest alarm flashes in the banner at the top of
the screen till it is acknowledged using [Ack All].
NOTE: Be sure to scroll to the bottom of the alarm
events list before using [Ack All] to ensure that all
alarms have been viewed.
Alarm notifications are color coded.
Red: Active, Unacknowledged Alarm
Green: Active, Acknowledged Alarm
Blue: Inactive, Unacknowledged Alarm
To view alarm events from the past, from the drop
down menu at bottom left, select ‘History’. Tap
[Period], and enter the start and end dates in a pop
up screen. Tap [Apply] to save changes or [Close]
to cancel.
Figure 27: Alarms Screen
EVENTS
Tap [Events] from the Operation menu.
This screen shows system events for current day,
date & time, and a short message about the event.
To view past events, tap [Period] and specify the
start and end date to view the events.
More events may be viewed using the vertical scroll
bar.