Xylem IM244R04 SPD Plus Variable Speed Pump Control - Manual (Page 13)

13
SECTION 6: POWER SUPPLY AND WIRING
(CONTINUED)
CONTROL TERMINAL CONNECTION DIAGRAM
The diagram below describes the control terminal connections.
NOTE
A jumper wire is installed between DI1 and +24V at the factory. To remotely start and stop the drive while in
REM mode, replace the jumper wire with a non-powered switch.
Identification RELAY OUTPUTS R04 TO R06
1 RO4C
2 RO4A
Relay output
3 RO4B
Default operation: Started
4 RO5C
5 RO5A
Relay output
6 RO5B
Default operation: Running
7 RO6C
8
RO6A
Relay output
9 RO6B
Default operation: Fault
FIGURE 4
NOTE
Pressure sensor cable must be wired during installation. All other connections are wired at the factory.