Xylem CG 843P User Manual
Page 43
Operation
115
Note
The
AutoStore
function is interrupted if you perform other
functions, e.g. output data storage.
After completing the other function, the
AutoStore
function
continues. However, as a result, gaps can occur in the
recording of the measured values.
Switching off the
AutoStore
Switch off the
AutoStore
function by:
l
Setting the storage interval (Int 1) to OFF or
l
Switch the pH meter off and on again.
5 As soon as all 200 memory locations are full, the
AutoStore function is terminated (Int 1 = OFF).
If too few storage locations are available for your
measurements:
– backup the data storage (see page 116) and
– clear the data stored (see page 119).
6 Confirm with <run/enter>.
The prompt for the I.D. number appears on the dis-
play.
7 Press <
▲
> <
▼
> to set the required I.D. number.
8 Confirm with <run/enter>.
The instrument changes to the pH measuring mode
and starts the measuring and storage procedure.
AutoStore
flashes on the display.