Xylem HandyLab 200 - Manual (Page 13)

HandyLab 200 Commissioning
13 ba77063e01 03/2014
Caution
Make sure that the poles of the batteries are positioned correctly.
The ± signs on the batteries must correspond to the
± signs in the
battery compartment.
Note
Alternatively, you can also use Ni-MH rechargeable batteries (type
Mignon AA). In order to charge the batteries, an external charging
device is required.
3.2.2 Switching on the meter
Note
The meter has an energy saving feature to avoid unnecessary battery
depletion.
The energy saving feature switches off the meter if no key is pressed
during the adjusted interval. (How to set the switch-off interval, see sec-
tion 4.3.1).
3.2.3 Setting the date and time
3 Place four batteries (type Mignon AA) in the battery compart-
ment.
4 Close the battery compartment.
1 Press the <On/Off> key.
The meter performs a self-test.
The display shows the manufacturer's logo while the self-test
is being performed.
Subsequently, the meter switches to the measuring mode
(measured value display).
1 See section 4.2.4