Xylem HandyLab 200 - Manual (Page 16)

Operation HandyLab 200
16 ba77063e01 03/2014
4.2.2 Navigation
Measured value display In the measured value display, you can
 open the menu for calibration and measurement settings with <F1>
(short keystroke)
 Open the Storage & config menu with the sensor-independent set-
tings with <F1
_
> (long keystroke (approx. 2 s).
 Change the display in the measurement window by pressing <M>
(e.g. conductivity
−> resistivity −> −> −> ).
Menus and dialogs The menus for settings and dialogs in procedures contain further sub-
elements. The selection is made with the <><> keys. The current
selection is displayed with a frame.
 Submenus
The name of the submenu is displayed at the upper edge of the
frame. Submenus are opened by confirming with <ENTER>. Exam-
ple:
 Settings
Settings are indicated by a colon. The current setting is displayed on
the right-hand side. The setting mode is opened with <ENTER>.
Subsequently, the setting can be changed with <><> and
<ENTER>. Example:
General
Clock
Service information
Reset
System
15.03.2014
10:00 Back
Language: Deutsch
Illumination : On
Contrast : 48 %
Switchoff time : 30 min
General
15.03.2014
10:00
Back