Xylem HandyLab 200 - Manual (Page 24)

Operation HandyLab 200
24 ba77063e01 03/2014
4.3.3 Automatic Stability control
The function, automatic Stability control (AutoRead) continually checks
the stability of the measurement signal. The stability has a considerable
impact on the reproducibility of measured values.
You can activate or switch off the automatic Stability control function
(see section 4.4.4).
The measured parameter flashes on the display
 as soon as the measured value is outside the stability range
 when you switch over between the measured parameters with <M>.
 when the automatic Stability control is switched off.