YSI MIQ/Blue PS Set User Manual
Page 25
MIQ/Blue PS
Installation
3 - 15
ba76095e02
01/2013
General installation
instructions
Observe the following points when attaching connecting wires to the
terminal strip:
Shorten all the wires to be used to the length required for the instal-
lation
Always fit all the ends of the wires with wire end sleeves before con-
necting them to the terminal strip
Any wires that are not used and project into the enclosure must be
cut off as closely as possible to the cable gland.
In each of the remaining free openings, screw in a small cable gland
with sealing ring and close them with a blind plug.
Warning
No free wires must be allowed to project into the enclosure. Oth-
erwise, there is a danger that areas safe to contact could come
into contact with dangerous voltages. This could result in life
threatening electric shock when working with the IQ S
ENSOR
N
ET
.
Always cut off any wires that are not in use as closely as possible
to the cable gland.