YSI MIQ/Blue PS Set User Manual
Page 27
Advertising
MIQ/Blue PS
Installation
3 - 17
ba76095e02
01/2013
Preparing the power
cable
Fig. 3-11 Prepared power cable.
Caution
The ground wire must not project into the enclosure. Otherwise,
malfunctions could occur.
1
Cut off the cable to the required length.
2
Strip the cable insulation for approx. 45 mm.
3
Bare the wires of phases L and N and fit them with wire end
sleeves.
4
If present, cut off the protective ground wire at the end of the
cable sheath.
ca. 45 mm
L
N
cut protective conducter here
Advertising