YSI IQ SensorNet TetraCon Sensor 700 IQ (SW) - Manual (Page 12)

Commissioning TetraCon
®
700 IQ (SW)
3 - 2 ba76018e01 01/2012
Connecting the sensor
to the sensor
connection cable
Fig. 3-1 Connecting the sensor
3.3 Commissioning / Getting the instrument ready for
measuring
1 Take the protective caps off the plug connections of the sensor
and the SACIQ (SW) sensor connection cable and keep them
safe.
2 Plug the jack of the SACIQ (SW) sensor connection cable onto
the plug head connector of the sensor. At the same time, rotate
the socket so that the pin in the plug head connector (1) clicks
into one of the two holes in the jack.
3 Then, screw the coupling ring (2) of the sensor connection
cable onto the sensor up to the stop.
1 Pull the protective cap off the sensor.
2 If required, assign a user-defined name to the sensor (see
relevant IQ S
ENSOR N ET system operating manual).
3 Set the sensor (see section 3.4).
SACIQ
1
2