YSI TruLab 1310P - Manual (Page 43)

TruLab pH 1310 Settings
ba76156e01 03/2014
43
ter in the measured value display and press the <F1>/[menu] or <MENU/
ENTER> key. After completing the settings, switch to the measured value dis-
play with <M>.
Default settings are printed in bold.
7.3 Sensor-independent settings
7.3.1 System
To open the Storage & config menu, press the <F1__>[Menu] key in the mea-
sured value display. After completing the settings, switch to the measured
value display with <M>.
Default settings are printed in bold.
Menu item Possible
setting Description
Man. temperature -25 ... +25
... +130 °C Entry of the manually determined tem-
perature. For measurements without
temperature sensor only.
Temperature unit °C
°F Temperature unit,
degrees Celsius or degrees Fahrenheit.
All temperatures are displayed with the
selected unit.
Resolution mV 0.1
1 Resolution of the mV display
Stability control On
Off Switches on or off the automatic stability
control during measurement (see sec-
tion Stability control (AutoRead) &
HOLD function, page 22 )
Reset - Resets all sensor settings to the delivery
condition (see section 7.4.1 R
ESETTING
THE MEASUREMENT SETTINGS , page 45).
Menu item Possible set-
ting Description
System / General /
Language Deutsch
English
(further) Selects the menu language
System / General /
Beep On
Off Switches on/off the beep on
keystroke
System / General /
Illumination Auto
On
Off Switches the display illumina-
tion on/off
System / General /
Contrast 0 ... 50 ... 100 % Changing the display contrast