Extron Electronics DMP 64 User Guide - Manual (Page 20)

DMP Software
This section describes the control software for the DMP 64, including:
• Software Control
• Embedded Web Pages
• Windows-based Program Control
• DSP Configurator Program Basics
• Audio level, Mix-point, Processing Blocks, and Signal Chains
• Mic/Line Input Signal Controls
• Ducker Tutorials
• Line Output Channels
• Virtual Bus Returns
• Primary Mix Matrix
• Secondary Mix Matrix
• Group Masters
• Digital I/O Ports
• Emulate Mode and Live Mode
• Presets
• Protected Configuration
• DSP Configurator Windows Menus
• Optimizing Audio Levels
Software Control
The DMP 64 can be controlled using the DSP Configurator software, SIS commands
through hyper terminal or DataViewer, or using embedded WebPages. IP Link functions
will be available through network connection including global viewer functionality.
The DMP 64 has the following connection options:
• RS-232 — One single stack 3-pole, 3.5 mm captive screw connector is used for
bi-directional RS-232 (±5 V) serial control.
See
Rear Panel Features and Cabling on page 5, for additional details on
connecting the RS-232 port.
• LAN — 10 Mbps, 100 Mbps, half duplex, full duplex connections are supported. Two
LEDs indicate connection and activity status. The device has the following default
Ethernet configurations:
IP Address: 192.168.254.254 Default Gateway: 0.0.0.0
Subnet Mask: 255.255.0.0 DHCP: OFF
See Rear Panel Features and Cabling on page 5, and Connection Options
on page 92 for additional details on connecting the LAN.
• USB 2.0 — A Mini B-type USB connector located on the front panel provides
high-speed USB 2.0 connectivity to a host computer, backward compatible to 1.0.
DMP 64 • Software Control 14