Extron Electronics DMP 64 User Guide - Manual (Page 78)

Deleting a Group Master
To delete a group:
1. Click Tools > Configure Groups to open the configure groups dialog box
or click View > Group Controls and then click Add a Group .
2. In the Select Group drop-down box, click a numbered group (such as "Group #1")
to select it.
3. Click the Delete Current Group button in the lower left area.
4. Click Yes in the Confirm Deletion dialog box.
Viewing and Using a Group Master
Click View > Group Controls to open the group controls dialog box (see figure 49). The
group controls dialog contains two menu items:
• Add a Group allows you to add additional groups.
• Tools enable you to perform various functions from the group controls window.
In addition, once groups are created, a single mute button or a group fader plus the
current setting readout and any soft limits that have been set are visible.
Figure 49. Group Controls Dialog Box
The group fader controls function as follows:
• Slide a group fader up and down to adjust all gain controls in the group.
• Click and drag a soft limit ( ) to set the ceiling and floor for the group.
NOTE: Soft limits cannot be dragged beyond the current setting of the group
fader.
Add a Group
To launch the configure groups dialog from the group controls window, click
Add a Group . When a new group is added and the Add New Group dialog is closed, the
group controls window refreshes to display the added control.
NOTE: If a block is muted when the group mute is selected, that block remains
muted when the group mute is released.
DMP 64 • Software Control 72