Extron Electronics MTPX Plus Series User Guide User Manual
Page 136
DHCP radio buttons
The
DHCP On
radio button directs the switcher to ignore any entered IP addresses and
to obtain its IP address from a Dynamic Host Configuration Protocol (DHCP) server (if the
network is DHCP capable). The
DHCP Off
radio button turns DHCP off. Contact the local
system administrator to determine if DHCP is appropriate.
IP Address field
The
IP Address
field contains the IP address of the connected switcher. This value is
encoded in the flash memory of the switcher.
Valid IP addresses consist of four 1-, 2-, or 3-digit numeric octets separated by dots (periods).
Each field can be numbered from 000 through 255. Leading zeroes, up to 3 digits total per
field, are optional. Values of 256 and above are invalid.
The factory-installed default address is 192.168.254.254, but if this conflicts with other
equipment at your installation, you should ask your network administrator for a new, valid
address.
NOTE: IP address changes can cause conflicts with other equipment. Only local system
administrators should change IP addresses.
Gateway IP Address field
The
Gateway IP Address
field identifies the address of the gateway to the mail server to
be used if the switcher and the mail server are not on the same subnet.
The gateway IP address has the same validity rules as the system IP address.
Subnet Mask field
The
Subnet Mask
field is used to determine whether the switcher is on the same subnet
as the mail server when you are subnetting. For more information, see “
”.
MAC Address field
The Media Access Control (MAC) Address is hardcoded in the switcher and cannot be
changed.
Firmware field
The
Firmware
field identifies the installed firmware version. This field is hardcoded in the
switcher and cannot be changed.
Model field
The
Model
field identifies the number of video and audio inputs and outputs. This field is
hardcoded in the switcher and cannot be changed.
Part Number field
The
Part Number
field identifies the part number of your switcher. This field is hardcoded
in the switcher and cannot be changed.
MTPX Plus Series • HTML Operation 130