Extron Electronics MTPX Plus Series User Guide User Manual
Page 71
Table 7.
Reset Mode Comparison/Summary
Mode
Activation
Result
Purpose/Notes
1
Hold down the recessed Reset button
while applying power to the switcher.
NOTE: After a mode 1 reset is
performed, update the
switcher firmware to the
latest version. Do not
operate the switcher
firmware version that
results from the mode 1
reset. If you want to
use the factory default
firmware, you must
upload that version
again (see the “
”section for
details on uploading
firmware).
The switcher reverts to the factory default
firmware. Event scripting will not start if the
switcher is powered on in this mode. All user files
and settings (such as drivers, adjustments, and IP
settings) are maintained.
NOTE: If you do not want to update
firmware, or you performed a mode 1
reset by mistake, cycle power to the
switcher to return to the firmware
version that was running before
the mode 1 reset. Use the 0Q SIS
command to confirm that the factory
default firmware is no longer running
(look for the asterisk [*] following the
version number.
Use mode 1 to revert
to the factory default
firmware version if
incompatibility issues
arise with user-loaded
firmware.
3
Hold down the Reset button for about 3
seconds, until the Reset LED blinks once,
then press and release Reset (<1 second)
within 1 second.
Mode 3 turns events on or off. During resetting,
the Reset LED flashes 2 times if events are starting, 3
times if events are stopping.
Mode 3 is useful for
troubleshooting.
4
Hold down the Reset button for about
6 seconds, until the Reset LED blinks
twice (once at 3 seconds and again at 6
seconds). Then press and release Reset
(<1 second) within 1 second.
Mode 4:
•
Enables ARP capability.
•
Sets the IP address to the factory default.
•
Sets the subnet address to the factory default.
•
Sets the gateway address to the factory default.
•
Sets port mapping to the factory default.
•
Turns DHCP off.
•
Turn events off.
The Reset LED flashes four times in quick succession
during the reset.
Mode 4 enables you
to set IP address
information using ARP
and the MAC address.
5
Hold down the Reset button for about
9 seconds, until the Reset LED blinks
three times (once at 3 seconds, again
at 6 seconds, and then again at 9
seconds). Then press and release Reset
(<1 second) within 1 second.
NOTE: Mode 5 reset clears
most adjustments. To
save these settings,
use the Windows-
based Matrix Switchers
Control Program and the
File > Save MATRIX
settings as...
selection before you
perform this reset (See
the “
section.
Mode 5 performs a complete reset to factory
defaults (with the exception of the firmware):
•
Does everything mode 4 does.
•
Resets most all real time adjustments, including:
clears all ties and presets,
clears all audio or RS-232 mutes,
clears all I/O grouping,
clears all input level/peaking,
clears all skew adjustments,
clears all output pre-peaking,
disables all RS-232 output inserts,
sets all audio/RS-232 wire pairs to audio,
clears all audio settings.
•
Resets all IP options.
•
Removes/clears all files for the switcher.
The reset LED flashes four times in quick succession
during the reset.
Mode 5 is useful if
you want to start over
with configuration and
uploading or to replace
events.
MTPX Plus Series • Operation
65