Extron Electronics MTPX Plus Series User Guide User Manual
Page 9
The switcher can be operated remotely by any of the following when that device is
connected to either MTPX Plus serial port:
•
A control system
•
A PC
•
An Extron MKP 2000 remote control panel
•
An Extron MKP 3000 remote control panel
For some outputs (most matrix sizes) or all outputs (MTPX Plus 128), bidirectional pass-
through RS-232 signals from a dedicated source (rather than from the selected input) can
be directly inserted into the signal set routed to the TP output. You can even route RS-232
on a link that is normally audio, such as to an MTP U R 15HD RSA SEQ receiver, which can
autodetect whether its signal input includes an audio component or an RS-232 component.
The matrix switchers are housed in metal enclosures. Most models have mounting flanges
for standard 19-inch racks built into the enclosure. The MTPX Plus 128 includes a kit for rack
mounting.
The switcher has an internal 100 VAC to 240 VAC, 50-60 Hz, 30 watt power supply that
provides worldwide power compatibility.
The MTPX Plus switcher has a minimum bandwidth of 300 MHz (-3 dB).
The switchers can also switch RGBS, RGsB, RsGsBs, HDTV, component video, S-video, and
composite video.
MTPX Plus Series • Introduction
3