Extron Electronics PowerCage FOX SR HDMI User Guide - Manual (Page 27)

PowerCage FOX SR HDMI Scaling Receiver • Remote Control 21
2. Select the Com port to which your receiver is connected. Click OK . The Signal
Processing Product Control Program window appears (see figure 13).
NOTE: The receiver does not have an Ethernet port. Do not select TCP/IP .
Figure 13. Signal Processing Product Control Program Window
Status area
Figure 14. Status Area
The status area provides indications of the connection status.
HDMI indicator — This indicator is green when the transmitter detects a sync signal on its
HDMI video input. The transmitter reports the status on the fiber cable.
Audio indicator — This indicator is green when the transmitter detects an audio signal
above a –35 dB threshold. It returns to unlit if the audio signal drops below the threshold for
10 seconds. The transmitter reports the status on the fiber cable.
Link 1 indicator — This indicator is green when the receiver detects light on the fiber optic
cable connected to the Tx port.
Link 2 (Optional) indicator — This indicator is green when the transmitter detects light on
the fiber optic cable connected to the Rx port. The transmitter reports the status on the fiber
cable.
NOTE: The transmitter detects the receiver-Tx-to-transmitter-Rx light. It reports the
status to the receiver via the Tx cable.
If the PC is connected to the receiver and either the primary (transmitter-
Tx-to-receiver-Rx) cable is disconnected or the receiver is in the daisy chain
mode, the Link 2 indicator in the control program will not show green
(detected), whether the transmitter detects the link or not.