Extron Electronics PowerCage FOX SR HDMI User Guide - Manual (Page 33)

PowerCage FOX SR HDMI Scaling Receiver • Remote Control 27
2. If you have not previously updated firmware for the PowerCage FOX unit, on the Add
Device screen (see figure
20), select the RS-232 tab.
Figure 20. Add Device Screen
If you have previously updated firmware for this model, click Cancel . The Firmware
Loader window appears. Proceed to step 5.
NOTE: The receiver does not have an Ethernet port. Do not select TCP/IP .
3. From the drop-down menus on the RS-232 screen, select the appropriate Com port
number and baud rate (the default is 9600).
4. Click OK . The Firmware Loader window appears (see figure 21).
5
Figure 21. Extron Firmware Loader Window
5. Select the PowerCage receiver and click File > Open . The Choose Firmware File
screen appears (see figure 22).
6
6
Figure 22. Choose Firmware File Window