Installing a board in the enclosure – Extron Electronics PowerCage FOX SR HDMI User Guide User Manual
Page 37
PowerCage FOX SR HDMI Scaling Receiver • Reference Information
31
Installing a Board in the Enclosure
Up to 16 single slot or 8 dual slot input/output boards can be inserted into the PowerCage
enclosure. The PowerCage receiver is a dual slot board.
ATTENTION: Use ESD precautions when installing a board to avoid damaging the
board. Keep the board in the anti-static bag until needed. Use proper
grounding techniques during installation.
NOTE: The board is hot-swappable, and can be installed or removed without
disconnecting power to the PowerCage enclosure.
1.
Ensure power is removed from the PowerCage enclosure.
2.
Position the board in the slot so that the power and communication ports on the
front end of the board are aligned with the matching ports inside of the board cage
(see figure
24).
5A MAX.
100-240V 50/60H
z
N15
778
C
US
LIS
TED
1T2
3
I.T.
E.
Screws (2 per board)
16 available single board slots or
8 double board slots
Power
Supply
Figure 24.
Inserting Boards into the PowerCage 1600 Enclosure
3.
Carefully slide the board into the slot and push the board firmly into place.
4.
Use a screwdriver to tighten the two screws to secure the board in place.
5.
Repeat steps
2 through 4 for all boards needing installation.
NOTE: Ensure the boards are flush with the rear of the enclosure and the screws
tightened securely before applying power.