Franklin Fueling Systems TS-LLD Installation Manual User Manual
Page 37
Figure 2.3-3 TS-LLD CU Typical Mounting and Conduit Routing
4) Mount the CU to the pump relay box (see Figure 2.3-3 above for typical
mounting methods). You may mount the control unit to a wall through the two 1/4
inch mounting holes — use fasteners that are appropriate for the wall
construction. The centers of these holes are shown on the inside label of the
control unit. In addition, make sure that the UP arrow is pointing up as shown in
Figure 2.3-2.
WARNING: DISCONNECT POW ER
BEFORE REMOVING COVER
PUM P RELAY BOX
WARNING: DISCONNECT POW ER
BEFORE REMOVING COVER
PUM P RELAY BOX
To 208/230 VAC
single phase
Power Source
(electrical power
panel) - circuit
breakers
To Submersible
Pump explosion
proof Junction Box
To Dispenser
Switch(es)
90° FITTING
- - Alternate Mounting A - -
NIPPLE
WARNING Av oid e le ctrical shock hazards. Disconne ct all e le ctrical powe r
source s BEFORE re mov ing any e nclosure cov e r !
NOTE: Ground e quipme nt as re quire d by your local and National Ele ctric Code s.
WARNING: DISCONNECT POW ER
BEFORE REMOVING COVER
- - Alternate Mounting B - -
PUM P RELAY BOX
WALL
MOUNTED
& EMT
NOTE
☞