ABUS TVIP72500 - Manual (Page 86)

86
6.2 Camera
General
Rotate image:
Settings for image orientation
Video clip format:
Choose between MPEG-4 and H.264 for the compression of the saved video clips (e.g.
for sending a video clip via SMTP e-mail). The H.264 option can result in the utilization
of more system resources, which can lead to a reduction in camera performance (e.g.
frame rate and motion detection).
Flip:
The picture is displayed rotated by 180°.
Reverse: The picture is displayed in mirror reverse.
Flip + reverse: Select this option if the camera was installed upside down.
Analog
video output:
Activate or deactivate the analog video output on the camera. This video output is used
for setting the focus.
The resolution 640x480 is not available and cannot be configured if the analog
video output is activated under “Camera / General”.
IR Cut Filter Mode:
Settings for the swiveled IR-cut filter (ICR)
Auto: The cut filter swivels in or out automatically according to the light sensor. The
“Threshold” option specifies the switching values.
Night mode: The swivel filter is constantly separated from the image sensor. The image
sensor can record visible light and IR light.
Day mode: The swivel filter is constantly in front of the image sensor. The image
sensor can only record visible light.
Schedule: The swivel filter is switched according to a schedule. The “ICR schedule”
option appears (for details on configuration, see 6.11, “Schedule”).
ICR Cut Filter Switch Delay:
Switching from day to night mode can be delayed by up to 10 seconds.
IR Cut Filter Threshold:
Bright (H) – The higher the value, the earlier the camera deactivates the IR-
cut filter / the IR light.
Dark (L) – The lower the value, the earlier the camera activates the IR-cut
filter / the IR light.
IR Mode:
Auto: The IR-LEDs are automatically activated or deactivated based on the limits of
the threshold value setting.
On: IR-LEDs are constantly activated.
Off: The IR-LEDs are constantly deactivated.