Alpha Technologies XM3-HP Series - Technical Manual - Manual (Page 43)

43 017-882-B0-001 Rev. C2 (10/2013)
2.0
Installation
Fig. 2-15, Front Panel Fastener Locations
Fig. 2-16, APPS Card Standoff, Screw and
Ribbon Cable Locations
Fig. 2-17, SAG Card Standoffs, Screws and
Ribbon Cable Locations
Remove all sources of power to unit before performing the following procedure.
WARNING!
Tools required:
#2 Phillips screwdriver
Procedure:
1. Remove the three fasteners securing
the front panel (see Fig. 2-15).
2. With the front panel open, install the
APPS card by pressing it firmly onto
the standoff (A) and fastening the
6-32 screw (B) (see Fig. 2-16).
3. Connect the ribbon cable (C) and
ensure the locking clips are closed.
4. Install the SAG card by pressing it
firmly onto the two standoffs (D) and
fastening the two 6-32 screws (E)
(see Fig. 2-17).
5. Connect the ribbon cable (F) and
ensure the locking clips are closed.
6. Reinstall the front panel and secure
with the fasteners removed in Step 1.
2.2 XM3-HP Start-Up Procedure, continued
2.2.5 Optional Smart AlphaGuard and Alpha APPS Installation
D
D
F
E
E
A
C
B
2.0 Installation, continued