Atec Agilent-1670G - Manual (Page 7)

7
Agilent Technologies 1670G Series
Specifications and Characteristics
Probes (general-purpose lead set)
Input resistance 100 k Ω, ±2%
Parasitic tip capacitance 1.5 pF
Minimum voltage swing 500 mV, peak-to-peak
Threshold accuracy* ±(100 mV + 3% of threshold setting)
Maximum input voltage ±40 V peak
State Analysis
Minimum state clock pulse width 3.5 ns
Time tag resolution [3] 8 ns or ± 0.1% (whichever is greater)
Maximum time count
between states
34.4 seconds
Maximum state tag
count between states
[3] 4.29 x 10 9 states
Minimum master-to-master
clock time*
6.67 ns
Minimum master-to-slave
clock time
0.0 ns
Minimum slave-to-master
clock time
4.0 ns
Clock qualifier
setup/hold
4.0/0 ns fixed
Timing Analysis
Sample period accuracy 0.01% of sample period
Channel-to-channel skew 2 ns typical (not > 3 ns)
Time interval accuracy ± (sample period accuracy + channel-to-channel
skew + 0.01% of time interval reading)
Minimum detectable glitch 3.5 ns
Triggering
Sequencer speed >150 MHz
Maximum occurrence counter 1,048,575
Range width 32 bits each
Timer value range 400 ns to 500 seconds
Timer resolution 16 ns or 0.1% (whichever is greater)
Timer accuracy ±32 ns or ±0.1% (whichever is greater)
Operating Environment
Temperature Instrument: 0°C to 55° C (+32°F to 131°F)
Disk media: 10°C to 40°C (+50°F to 104°F)
Probe lead sets and cables:
0°C to 65°C (+32°F to 149°F)
Humidity Instrument: up to 95% relative humidity at +40° C
Disk media and hard drive: 8% to 85% relative
humidity
Altitude 4,572 m (15,000 ft)
[3] Time or state tags halve the acquisition memory when there are no unassigned pods.
* Warranted Specifications
370 ohms
GROUND
1.5pF 7.4pF
100 K
ohm
Figure 15. Equivalent Probe Load for the
01650-61608 General-Purpose Lead Set.