B&K Precision 886 - Manual - Manual (Page 5)

2
more expensive LCR bridge in many situations. The meter is
powered from two AA Batteries and is supplied with an AC to DC
charging adapter and two AA Ni-Mh Rechargeable Batteries.
The instrument has applications in electronic engineering labs,
production facilities, service shops, and schools. It can be used to
check ESR values of capacitors, sort values, select precision values,
measure unmarked and unknown inductors, capacitors or resistors,
and to measure capacitance, inductance, or resistance of cables,
switches, circuit board foils, etc.
The key features are as following:
 Test condition:
1 Frequency : 100Hz / 120Hz / 1KHz / 10KHz /
100KHz (886)
2. Level : 1Vrms / 0.25Vrms / 50mVrms /
1VDC (DCR only)
 Measurement Parameters
: Z, Ls, Lp, Cs, Cp, DCR,
ESR, D, Q and θ
 Basic Accuracy: 0.2%
 Dual Liquid Crystal Display
 Fast/Slow Measurement
 Auto Range or Range Hold
 Open/Short Calibration
 Primary Parameters Display:
Z : AC Impedance
DCR : DC Resistance
Ls : Serial Inductance
Lp : Parallel Inductance