Dialight D1RW-L13-008 Vigilant L866/L885 LED Based Dual Red / White Catenary - Manual (Page 13)

Document No.
9100-127-1426-99 Rev D
Release Date: 10/26/2010
_____________________________________________________________________
_____________________________________________________________________________
Dialight Corporation 1501 Route 34 South Farmingdale NJ 07727
Tel: 732.919.3119 Fax: 732.751.5778 Web: www.dialight.com
Page 13 of 25
Section 10: Mounting the Flash Head
Dialight recommends the installation of one or more lightning rods near the
installed Flash Head. The lightning rods should extend a minimum of three feet
above the height of the Flash Head.
The Flash Head is mounted to the tower pedestal utilizing customer supplied ½”
hardware. Six mounting holes are provided on the Flash Head base (Figure 2).
These mounting holes will align with most tower pedestals. The Flash Head
must be installed level according to the bulls-eye level on the light engine to
maintain light output in accordance with FAA requirements.
BASE – BOTTOM VIEW