MoTeC ADL3 EDL3 - Manual (Page 10)

6 Introduction
Video
Multiple video streams, from in-car cameras for example, can be linked
with logged data for synchronised playback of footage alongside other
analysis components. Synchronised video requires a standard video
capture device and the Pro Analysis upgrade to provide access to i2 Pro
data analysis software.
Synchronisation can be completed manually or automated by recording
regular sync points onto the audio track of the video camera. This requires
the small Video Sync Module (VSM) connected to an auxiliary output of
the ADL3 and to the audio input of the camera.
Lambda Measurement
PLM
The PLM Professional Lambda Meter measures the air fuel ratio over a
wide range of mixtures with fast response time. It is compatible with Bosch
LSU and NTK UEGO Lambda sensors and displays the Lambda readings
via the integrated display.
LTC/LTCD
The LTC Lambda to CAN modules provide accurate Lambda
measurements even when the exhaust gas temperature changes rapidly.
They are compatible with the Bosch LSU 4.9 Lambda sensor and transmit
Lambda readings via the CAN bus.
Displays
A display device may be connected to the ADL3 to allow display of any value
that the ADL3 calculates, such as lap times and warning alarm messages.
The ADL3 supports MDD displays which are connected via CAN.
PDMs
Power Distribution Modules are designed to replace conventional relays,
fuses and circuit breakers by providing electronically switched power to the
various electrical systems in the vehicle. This simplifies wiring and switch
requirements, while increasing reliability.
Full diagnostic information, including output currents and error status can be
transmitted via CAN to the ADL3.
Several models are available to suit vehicles with different complexity ranging
from 15 to 32 outputs and 12 to 23 inputs.
Other Devices
Many other devices can be connected to the ADL3. Contact your dealer for
advice.