MoTeC ADL3 EDL3 - Manual (Page 32)

28 Configuration
The bottom alpha / numeric display may be used to display additional
information as needed.
Warm-up Mode
The Warm-up display is used to display important engine sensor readings
during engine warm-up, e.g. RPM, Battery Voltage, Engine Temperature,
Oil Pressure, Oil Temperature and Fuel Pressure.
The bottom alpha / numeric display can be used to check many other
warm-up values.
Bar Graph
The 70 segment bar graph has a user definable range and is typically used as
a tacho, however it can be used to display any other value. When used as a
tacho it may be configured for up to 19000 RPM.
A fully programmable shift point can be displayed, which can also be gear
dependent.
The operation of the bar graph can be different for each of the display modes
(Race Practice and Warm-up), this allows a lower range to be used in Warm-
up mode.
Numeric Displays