Castle Equalizer Edgebander User Manual
Page 10
Adjusting the machine for different thicknesses of tape can be done with the screw directly
behind the tape and above the work surface. Loosen the screw and slide the plate right or
left to adjust the amount of drag, so the tape stays in position without falling.
Plug in the machine.
To test, begin by making sure the machine is warmed up and in Run Mode (see page 10 for
Mode definitions). The light should be on solid. Expose the tape to the point where it is
JUST at the bottom of the Guide Rail. Roll a test board across the Glue Pot, and all the way
to the last roller. As you pass the Guillotine, it should cut the banding off.
The bond is best after the glue has had time to cool.
If you pull the tape off it should try to take the wood with it.
8