Castle Equalizer Edgebander - Manual (Page 18)

ƒ With the Clamp released, use a pair of pliers to grab the lip of the Glue Pot. Pull it out
and place it on the Galvanized Shelf.
ƒ Reverse this procedure to install the Glue Pot, making sure it is installed all the way
back onto the rear of the Hot Plate. Fill the empty Glue Pot with glue pellets to the top
of the Transfer Wheel Axle prior to installation.
glue color changing instructions
ƒ Place a bucket or box under the Equalizer at the Magazine, and pull the Magazine Gate out
about 2 inches or until it stops. The glue pellets will drop out of the bottom of the machine.
ƒ Make sure to change the Glue Pot (refer to above instructions on how to change the Glue Pot),
and allow time for warm-up.
16