Castle Equalizer Edgebander User Manual
Page 7
Remove your Glue Pot by first loosening the Start Knob directly beneath the Glue Pot on
the under side of the machine.
With the Glue Pot out of the machine, add Glue Pellets directly to the pot until the Transfer
Wheel Axle is covered. **The Equalizer is sent out with CanPlast brand pellets. If you
would like to use a different brand, DO NOT fill the Glue Pot with the pellets supplied!
This addition of Glue Pellets outside the machine is only done when starting with a
completely emptied Pot. The auto-fill mechanism will work for this, but it’s slower this
particular start-up procedure.
Unwrap the Glue Pot Shield with the Castle logo on it (found inside machine). The Glue
Pot Shield sits on the yellow Mechanical Channel with the tabs on the rear of the shield
fitting into the Positioning Holes.
5