Transfer wheel has a dry line, Tape edges not centered enough on board edge, Tape edges not even – Castle Equalizer Edgebander User Manual
Page 26
transfer wheel has a dry line
The Glue Pot may have become contaminated. While the Glue Pot is hot, remove the
top, dump the liquid glue, and scrape out any foreign matter along the bottom of the
Pot.
The Glue Pot may need to be cleaned.
Tape edges not centered enough on board edge
The machine is factory set to place the tape closest to the edge of the board that is
facing IN from the machine when running the board. This means that a larger amount
of excess tape will be sticking over the edge of the board that is facing OUT when
running the board. This excess exists to accommodate thicker stock, and when thinner
stock is run it is simply cut off.
Tape edges not even
The Sprung Wheel Rollers may not be working evenly. It is possible that the springs
may have fallen out. Look in from the back of the machine and confirm that they are
all in place.
24