Climax VM1200 GATE VALVE GRINDING & LAPPING - Manual (Page 7)

Mrz-06 / VM1150-1200 Gate Valve Grinding & Lapping Machine Brochure.doc
Page 7 of 9
Accessories
P/N Description
Grinding adapter
For using the tooling of the VM1150(S) on stationary drill
presses. The grinding pressure is made by an application of
springs.
The scale for the grinding pressure is divided into two
ranges: One for high rate of removal of material and the
other for high precision surfaces.
185-00S-S22 Grinding adapter MT2
For using on stationary drill presses with morse taper #2.
185-00S-S23 Grinding adapter MT3
For using on stationary drill presses with morse taper #3.
Planet Arms 3 degrees
The spindles of these arms are designed with a 3 degree
offset. These arms are made to rework the 3 degree relief
angle in gate valves
110-51S-N01 Planet arm #II 3 degrees (2.4”(60 mm) length) (each)
(A total of five required)
Outside grinding diameter 6.3”-13.0”(160-330 mm)
(diameter depends on selected planet wheel)
110-52S-N01 Planet arm #III 3 degrees (4.5”(115 mm) length) (each)
(A total of five required)
Outside grinding diameter 13.0”-21.7”(330-550 mm)
(diameter depends on selected planet wheel)
110-50S-L01 3 degree Planet Arm Set
Includes :
•
Planet arm #II 3 degree (5 pieces)
•
Planet arm #III 3 degree (5 pieces)
Planet Arms 5 degree
The spindles of these arms are designed with a 5 degree
offset. These arms are made to rework the 5 degree relief
angle in gate valves
110-61S-N01 Planet arm #II 5 degrees (2.4”(60 mm) length) (each)
(A total of five required)
Outside grinding diameter 6.3”-13.0”(160-330 mm)
(diameter depends on selected planet wheel)
110-62S-N01 Planet arm #III 5 degrees (4.5”(115 mm) length) (each)
(A total of five required)
Outside grinding diameter 13.0”-21.7”(330-550 mm)
(diameter depends on selected planet wheel)
110-60S-L01 5 degree Planet Arm Set
Includes :
•
Planet arm #II 5 degree (5 pieces)
•
Planet arm #III 5 degree (5 pieces)