CEMB USA ER100 (A) - Manual (Page 2)

6.14 WHEEL ANALYSIS 37
6.14.1 Runout 38
6.14.1.1 When and why TO USE MATCHING 38
6.14.1.2 Matching 39
6.14.1.2.1 When to perform matching 40
6.14.1.2.2 How to perform matching 40
6.14.1.3 Peak/peak and fi rst harmonic graphs 41
6.14.2 Tread 42
6.14.3 Taper 44
6.15 OUTSIDE RIM RUNOUT 45
7 SETUP 47
7.1 MENU 47
7.2 GENERAL SETUP 48
7.2.1 General setup 1/3 48
7.2.1.1 Screensaver customisation 50
7.2.2 General setup 2/3 51
7.2.3 General setup 3/3 52
7.3 RESERVED SETUP 53
7.3.1 LASER calibration 54
7.3.2 Spindle reset 55
7.3.3 Taper calibration 56
7.3.4 Correction weights 57
7.3.5 Wheel runout 58
7.3.6 Outside rim runout 59
7.3.7. Tread 60
7.3.8 Firmware upgrade 61
7.3.9 Factory setting 62
7.4 MACHINE CALIBRATION 63
7.5 DIMENSIONS 64
7.6 SELF-DIAGNOSTICS 65
7.7 OSK 66
7.8 SOUNDS 67
8. DIAGNOSTICS 68
9. MAINTENANCE 71
9.1 GENERAL 71
9.1.1 Introductory notes 71
9.1.2 Safety rules 71
9.1.3 Replacing fuses 71
10. DISPOSAL 72
10.1 DISPOSING OF THE BALANCER 72
10.2 DISPOSING OF ELECTRONICS COMPONENTS 72
11. SPARE PARTS 72
11.1 IDENTIFICATION AND ORDERING METHOD 72
12. ATTACHED DOCUMENTATION 72