CEMB USA K9 (A) - Manual (Page 19)

I 0615 - 19 GB
7 - ERRORS
During machine operation there may be various causes of malfunctioning which, if detected by the microprocessor,
are indicated on the display:
ERRORS CAUSES CONTROLS
Black The wheel balancer does not come on. 1. Check proper connection to the mains.
2. Check and if necessary replace the fuses on the power board.
3. Replace the computer board.
Err. 1 No rotation signal. 1. Check belt tautness.
2. Check functioning of the phase generator and, in particular, the
reset signal.
3. Replace the phase generator.
4. Replace the computer board.
Err. 2 Too low speed during measurement.
During the unbalance measurement
revolutions, the wheel speed has fallen to
below 42 rpm. 1. Check that a vehicle wheel has been mounted on the wheel
balancer.
2. Check belt tautness.
3. Check functioning of the phase generator and, in particular, the
reset signal.
4. Replace the computer board.
Err. 3 Too high unbalance. 1. Check the wheel dimension setting.
2. Check the sensor connections.
3. Run the machine calibration function.
4. Mount a wheel with a more or less known unbalance (less than 100
grams) and check the machine response.
5. Replace the computer board.
Err. 4 Rotation in opposite direction.
After pressing [START], the wheel
starts turning in the opposite direction
(anticlockwise). 1. Verify the connection of the UP/DOWN - RESET signals on the
phase generator.
Err. 5 Guard open
The [START] pushbutton was pressed
without fi rst closing the guard. 1. Reset the error.
2. Close the guard.
3. Verify the function of the protection uSwitch.
4. Press the [START] button.
Err. 7 /
Err. 8 /
Err. 9 NOVRAM parameter read error 1. Repeat machine calibration
2. Shut down the machine.
3. Wait for at least ~ 1 min.
4. Restart the machine and check proper functioning.
5. Replace the computer board.
Err. 11 Too high speed error.
The average spinning speed is greater than
240 rpm. 1. Check if there is any damage or dirt on the timing disc.
2. Check functioning of the phase generator and, in particular, the
reset signal.
3. Replace the computer board.
Err.14/
Err.15/
Err.16/
Err.17/
Err. 18/
Err. 19 Unbalance measurement error. 1. Check functioning of the phase generator.
2. Check the sensor connections.
3. Check the machine earthing connection.
4. Mount a wheel with a more or less known unbalance (less than 100
grams) and check the machine response.
5. Replace the computer board.
Err.21 Motor on for more than 15 seconds. 1. Check functioning of the phase generator.
2. Check the connections on the power board.
3. Replace the computer board.
Err.22 Maximum number of spins possible for
the unbalance measurement has been
exceeded. 1. Check that a vehicle wheel has been mounted on the wheel
balancer.
2. Check belt tautness.
3. Check functioning of the phase generator and, in particular, the
reset signal.
4. Replace the computer board.
Err. 24 Distance between the spokes smaller
than 18 degrees. 1. The minimum distance between the spokes where to split the
unbalance must be greater than 18 degrees
2. Repeat the SPLIT function increasing the distance between the
spokes.
Err. 25 Distance between the spokes greater
than 120 degree 1. The minimum distance between the spokes where to split the
unbalance must be smaller than 120 degrees
2. Repeat the SPLIT function increasing the distance between the
spokes.