AAON SB-018 - Manual (Page 19)

19
Figure 3 - SB Series Unit Orientation
Lifting and Handling the Unit
Before lifting unit, be sure that all shipping
material has been removed from unit.
Care should be taken if using spreader bars,
blocking or other lifting devices to prevent
damage to the cabinet, coil or fans.
Refrigerant-to-Water Heat Exchanger
Water Piping
Condenser water pump, condenser water
piping, cooling tower, pressure gauges,
strainers, piping insulation and all
components of the waterside piping must be
field installed.
Open Loop Applications
This product contains one or more
refrigerant-to-water heat exchangers made
of cupronickel or copper and is subject to
severe corrosion and failure when exposed
to chlorides.
UNIT HANDLING
Incorrect lifting can cause damage to
the unit, injury or death. Lifting
equipment capacity should exceed
unit weight by an adequate safety
factor. Always test lift unit not more
than 24 inches high to verify proper
center of gravity lift point.
WARNING
OPEN LOOP APPLICATIONS
Failure of the condenser as a result
of chemical corrosion is excluded
from coverage under AAON Inc.
warranties and the heat exchanger
manufacturer’s warranties.
WARNING
Connections and service
access on right side for
right hand orientation
Right Hand Side
Left Hand Side
Supply Air
Return Air
Compressor and Heat
Exchanger Compartment
SB Series Top View
Air Flow
Consider the air flow to be
hitting the back of your head.