Analog Way Tetra-VIO - Manual (Page 12)

Chapter 2 : STARTING (continued) TETRA VIO
2-2. INPUT #1 DESCRIPTION
 CONNECTION:
You can connect to this input one of the following source:
• A composite video source on the Y BNC connector or on the COMPUTER/TV/HDTV HD15 (bottom)
connector.
• A S.VIDEO source on the Y and Cr BNC connectors or on the COMPUTER/TV/HDTV HD15 (bottom)
connector.
• A Component video source (YCrCb or HD-YCrCb) on the Cr, Y and Cb BNC connectors or on the
COMPUTER/TV/HDTV HD15 (bottom) connector.
• A RGBS source on the R, G, B and S BNC connectors or on the COMPUTER/TV/HDTV HD15 (bottom)
connector.
• An analog (RGBHV, RGsB, RGBS) computer source on the HD15 COMPUTER/TV/HDTV (bottom) connector.
 LOOP OUT:
You can connect a control monitor to the HD15 (LOOP OUT) connector. This connector can be used as well with
analog sources connected to the BNC inputs.
 INPUT #1 CONNECTION DIAGRAM:
 HD15 PIN ASSIGNMENT:
SIGNAL COMPUTER (analog) VIDEO RGB/S YUV & HDTV (analog) S.VIDEO (Y/C) COMPOSITE VIDEO
PIN 1 RED. RED. Cr / Pr. C (chrominance).
PIN 2 GREEN. GREEN. Y. Y (luminance). VIDEO (NTSC, PAL...)
PIN 3 BLUE. BLUE. Cb / Pb.
PIN 6 RED return. RED return. Cr / Pr return. C return.
PIN 7 GREEN return. GREEN return. Y return. Y return. return.
PIN 8 BLUE return. BLUE return. Cb / Pb return.
PIN 10 GND. GND.
PIN 13 H sync or C sync (S). C sync (S).
PIN 14 V sync.
HD15 female connector of the device.
5
6
1
15
10
11
PAGE 12