Analog Way Tetra-VIO - Manual (Page 13)

TETRA VIO Chapter 2 : STARTING (continued)
2-3. INPUT #2 DESCRIPTION
 CONNECTION:
You can connect to this input one of the following source:
• A digital computer source on the DVI-I (IN) connector.
• An analog computer source (RGBHV, RGsB, RGBS) on the DVI-I (IN) connector.
NOTE: You can use the DVI / HD15 adaptor provided with the device to connect analog sources on the DVI-I (IN)
connector.
• You can also connect to this input a composite video source or a S.VIDEO source or a Component video source
(YCrCb or HD-YCrCb) or a RGBS source. For the connection of these sources you may required the adaptors
provided with the device.
 LOOP-THROUGH:
You can connect a control monitor to the DVI-I (LOOP OUT) connector.
 INPUT #2 CONNECTION DIAGRAM:
 DVI-I PIN ASSIGNMENT:
This connector can be used with digital signals as well as analog signals. The table hereafter explain the pin
assignment of these connectors.
Pin Function Pin Function Pin Function
1 TMDS Data 2- 9 TMDS Data 1- 17 TMDS Data 0-
2 TMDS Data 2+ 10 TMDS Data 1+ 18 TMDS Data 0+
3 TMDS Data 2 Shield 11 TMDS Data 1 Shield 19 TMDS Data 0 Shield
4 Not used. 12 Not used. 20 Not used.
5 Not used. 13 Not used. 21 Not used.
6 DDC Clock 14 + 5V (Power) 22 TMDS Clock Shield
7 DDC Data 15 Ground for (+5V) 23 TMDS Clock+
8 Analog Vertical Sync. 16 Hot plug detect. 24 TMDS Clock-
C1 Analog Red video (or Cr / Pr or C)
C2 Analog Green Video (or Y or composite video)
C3 Analog Bleu Video (or Cb / Pb)
C4 Analog Horizontal Sync (or composite sync)
C5 Analog Common Ground Return
DDC = Display Data Channel.
TMDS = Transition Minimized Differential Signal.
2-4. INPUT #3 DESCRIPTION
 CONNECTION:
You can connect a SD-SDI or HD-SDI source on the SD/HD-SDI BNC connector.
 LOOP-THROUGH:
You can connect a control monitor to the BNC (LOOP OUT) connector.
 INPUT #3 CONNECTION DIAGRAM:
8 1
9 16
24 17
C1 C2
C3 C4
C5
PAGE 13