General information – Burkert Type 8750 User Manual
Page 7
7
General information
Typ 8750
▶ That the system cannot be activated unintentionally.
▶ After an interruption in the power supply or pneumatic supply,
ensure that the process is restarted in a defined or controlled
manner.
▶ The device may be operated only when in perfect condition and
in consideration of the operating instructions.
▶ The general rules of technology apply to application planning and
operation of the device.
▶ Do not supply the pilot air port with aggressive or flammable media.
▶ Do not supply the pilot air port with liquids.
▶ Do not physically stress the body (e.g. by placing objects on it or
standing on it).
▶ Do not make any internal or external changes on the device.
note!
electrostatic sensitive components/modules.
The device contains electronic components which react sensitively
to electrostatic discharge (ESD). Contact with electrostatically
charged persons or objects are hazardous to these components.
In the worst case scenario, they will be destroyed immediately or
will fail after start-up.
▶ Observe the requirements specified in EN 61340-5-1 to minimize/
avoid the possibility of damage caused by a sudden electrostatic
discharge.
▶ Do not touch electronic components while the supply voltage is
switched on.
5. General informaTion
5.1. contact address
germany
Bürkert Fluid Control Systems
Sales Center
Christian-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tel. + 49 (0) 7940 - 10 91 111
Fax + 49 (0) 7940 - 10 91 448
E-mail: [email protected]
international
Contact addresses can be found on the final pages of the printed
operating instructions.
And also on the Internet at:
5.2. Warranty
The warranty is only valid if the flow controller Type 8750 is used as
intended in accordance with the specified application conditions.
5.3. information on the internet
The operating instructions and data sheets for Type 8750 / Type 8693
can be found on the Internet at:
english