8 commissioning, 1 safety instructions, 2 commissioning procedure – Burkert Type 8035 User Manual
Page 48: Commissioning, Safety instructions, Commissioning procedure, 8commissioning
46
Commissioning
8
CommissioninG
8.1
safety instructions
Warning
Danger due to non-conforming commissioning.
Non-conforming commissioning could lead to injuries and damage the device and its surroundings.
▶ Before commissioning, make sure that the staff in charge have read and fully understood the contents of the
operating instructions.
▶ In particular, observe the safety recommendations and intended use.
▶ The device / the installation must only be commissioned by suitably trained staff.
protect this device against electromagnetic interference, ultraviolet rays and, when installed out-
doors, the effects of the climatic conditions.
8.2
Commissioning procedure
Before commissioning the device:
→
Enter the K factor of the fitting used. See chap. “9.7.3”.
→
Wire the device depending on the desired dosing mode. See chap. “7.6” and chap. “9.6.1” to “9.6.7”.
→
If the digital inputs are used, place DI4 in the off-position before energizing the device.
→
Set the dosing mode. See chap. “9.7.5”.
English
Type 8025 - 8035 BATCH