ELRO HA68S Multi-zone professional alarm system USERS MANUAL - Manual (Page 11)

-9- -56-
MOUNTING THE CONTROL PANEL
1. Undo the two captive fixing screws on top of the panel and open the cover.
The cover is hinged along the bottom edge.
2. Unclip and remove the two back-up batteries on either side of the panel.
3. Hold the Control Panel in position on the wall and mark the positions of the
four fixing holes. Remove the Panel and drill four 5mm holes and fit the
25mm Wall Plugs.
IMPORTANT: Do not drill the fixing holes with the Control Panel in position;
as the resulting dust and vibration may damage the Control Panel’s internal
components and invalidate the guarantee.
4. Fit two 18mm No.4 screws into the top holes until almost fully home and hang
the Control Panel over these screws using the two keyhole slots in the top
corners of the panel casing.
5. Route the cable from the Power Supply Unit up behind and on the right hand
side of the Control Panel and connect the plug to the DC power socket in the
panel. Ensuring that the cable is not trapped between the panel and the wall.
6. Fix the Panel to the wall using two 18mm No. 4 screws in the lower two fixing
holes in the panel and tighten the upper fixing screws until they just grip the
casing. Do not over tighten the fixing screws as this could damage or distort
the casing.
7. Ensure that the ‘Reset’ and the ‘Hard-Wired
Siren tamper detect’ jumper links are set in the OFF position.
8. Connect battery leads to both back-up batteries and refit batteries.
Battery 1 (left): Red lead to +ve battery terminal
Blue lead to –ve battery terminal
Battery 2 (right): Blue lead to +ve battery terminal
Black lead to –ve battery terminal
IMPORTANT: Take care when connecting battery leads to the batteries as
connecting incorrectly could damage the batteries or the Control Panel.
Note: The Power LED may flash to indicate that the unit is being operated
from the back-up batteries and that mains supply is not present.
9. If fitted, remove the plastic film covering the LCD display and on the display
window on the cover.
10. Close the lid of the Control Panel and tighten the captive fixing screws.
11. Plug in and switch ON the Power Supply Unit, (the Power LED should
illuminate).
ARM
The system can be set in ARM mode using either the Remote Control or the
Control Panel as follows:
Remote Control:
Press the ‘ARM’ button,
Control Panel:
Press the Arm button followed by the User Password and then the Enter button:
User Password
By pressing , the programmed exit delay will be overrided to 5 seconds.
PART-ARM 1
The system can be set in PARTIAL Arm 1 mode using either the Remote Control
or the Control Panel as follows:
Remote Control:
Press the ‘PARTIAL ARM’ button, .
Control Panel:
User Password
By pressing , the programmed exit delay will be overrided to 5 seconds.
PARTIAL ARM 2
The system can be set in Partial Arm 2 mode using either the Remote Control or
the Control Panel as follows:
Remote Control:
Press the ‘PARTIAL ARM’ button twice, , .
Control Panel:
User Password
By pressing , the programmed exit delay will be overrided to 5 seconds.
DISARM
The system can be Disarmed using either the Remote Control or the Control
Panel as follows:
EN EN